Surface photovoltage spectroscopy of dye-sensitized solar cells with TiO₂, Nb₂O₅, and SrTiO₃ nanocrystalline photoanodes: Indication for electron injection from higher excited dye states

The onset wavelengths of the surface photovoltage (SPV) in dye-sensitized solar cells (DSSCs) with different mesoporous, wide-band gap electron conductor anode materials, viz., TiO₂ (anatase), Nb₂O₅ (amorphous and crystalline), and SrTiO₃, using the same Ru bis-bipyridyl dye for all experiments, are different. We find a clear dependence of these onset wavelengths on the conduction band edge energies (E_CB) of these oxides. This is manifested in a blue-shift for cells with Nb₂O₅ and SrTiO₃ compared to those with TiO₂. The E_CB levels of Nb₂O₅ and SrTiO₃ are known to be some 200-250 meV closer to the Vacuum level than that of our anatase films, while there is no significant difference between the optical absorption spectra of the dye on the various films. We, therefore, suggest that the blue shift is due to electron injection from excited-state dye levels above the LUMO into Nb₂O₅ and SrTiO₃. Such injection comes about because, in contrast to what is the case for anatase, the LUMO of the adsorbed dye in the solution is below the E_CB of these semiconductors, necessitating the involvement of higher vibrational and/or electronic levels of the dye, with the former being more likely than the latter. While for Nb₂O₅ hot electron injection has been proposed earlier, on the basis of flash photolysis experiments, this is the first evidence for such ballistic electron-transfer involving SrTiO₃, a material very similar to anatase but with a significantly smaller electron affinity. Additional features in the SPV spectra of SrTiO₃ and amorphous Nb₂O₅ (but not in those of crystalline Nb₂O₅) can be understood in terms of hole injection from the dye into the oxide via intraband gap surface states.